Note : Packet Tracer output for show ipv6 protocols is currently not aligned with IOS 15 output. Use the following commands to gather information about your OSPFv3 multiarea implementation. Step 2: Use show commands to examine OSPFv3 operation. RC( config-if)# ipv6 ospf 1 area 0 Part 2: Verify Multiarea OSPFv3 Operations Step 1: Verify connectivity to each of the OSPFv3 areas.įrom RA, ping each of the remote devices in area 0 and area 2: RC( config-if)# interface GigabitEthernet0/1 RC( config- rtr )# interface GigabitEthernet0/0 RB( config- rtr )# interface GigabitEthernet0/0 The router ID for RB should be 2.2.2.2 and the router ID for RC should be 3.3.3.3. RA( config-if)# ipv6 ospf 1 area 0 Step 3: Configure OSPFv3 on RB and RC. RA( config-if)# interface GigabitEthernet0/1 RA( config)# interface GigabitEthernet0/0 RA( config- rtr )# router-id 1.1.1.1 Step 2: Advertise each directly connected network in OSPFv3 on RA.Ĭo nfigure each active IPv6 interface with OSPFv3 assigning each to the area listed in the Addressing Table. Configure OSPFv3 on RA with a process ID of 1 and a router ID of 1.1.1.1.Instructions Part 1: Configure OSPFv3 Step 1: Enable IPv6 routing and configure OSPFv3 on RA. Your job is to enable multiarea OSPFv3, verify connectivity and examine the operation of multiarea OSPFv3. The network is already connected and interfaces are configured with IPv6 addressing. In this activity, you will configure multiarea OSPFv3. Part 2: Verify Multiarea OSPFv3 Operations Background / Scenario
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
January 2023
Categories |